SMS Messaging
SMS Messaging lets NZ Leads hold a real two-way text conversation with your lead on a dedicated phone number. The lead gets a welcome text, can reply, and - if you turn on AI - the assistant keeps the conversation going over SMS, with its own follow-up sequence. It runs alongside the lead’s original channel (Yelp, Thumbtack, etc.), not instead of it.
SMS Messaging is not the same as the SMS integration. The SMS integration texts you (the business) a heads-up when a new lead arrives. SMS Messaging texts the lead and carries on the conversation. This page is about the second one.
Before texts actually go out, you complete a one-time SMS Messaging registration (carrier-required for business texting in the US). There’s a registration fee and a small monthly fee - see Pricing and registration below.
Getting here
In NZ Leads, go to Sources → select a source → Messaging Settings → Conversation Setup tab.
The Conversation Setup tab has two parts:
- How replies work - marked with the source’s platform (e.g. Yelp, Thumbtack) - controls replies on the original channel.
- The SMS panel (Configure an optional SMS conversation channel.) - controls the text-message channel described here.
The SMS panel opens when you turn SMS on; everything below is set inside it.
Turning it on
Enable SMS messaging
Turn on the switch in the SMS panel’s header (default: off). The panel opens and the rest of the SMS options appear.
Pick a sender phone number
Under Sender Phone Number, click Select Phone Number. This is the number SMS welcome messages and follow-ups are sent from - recipients see it as the sender and can reply to it. Use Change Phone Number later to swap it.
Complete SMS Messaging registration
Once a sender number is selected, click the SMS Messaging button next to it to open registration and submit your business for carrier review. SMS won’t actually send until registration is approved - the panel reminds you: “SMS messages will start sending once your SMS Messaging registration is approved.” See Pricing and registration.
Choose how SMS replies are written
Use the Predefined Messages / AI Assistant toggle to pick the mode (details below).
Predefined vs AI mode
Just like the primary channel, the SMS channel runs in one of two modes. They’re chosen independently - the primary channel can be on AI while SMS is on predefined, or any combination.
Predefined Messages (SMS)
You write a single SMS welcome message that’s sent once the lead’s phone number is known (see When the SMS welcome is sent). Unlike the primary channel’s predefined list, the SMS welcome is one message (no keyword triggers).
- Text only, ASCII characters only, maximum 160 characters (one SMS segment).
- An optional welcome message delay is available (same control as the primary channel).
AI Assistant (SMS)
The AI writes the SMS welcome and, depending on the conversation mode, keeps replying to the lead over text. These are the same per-channel controls described on the AI Assistant page - here they apply to the SMS channel. When the AI is on for SMS you can set:
- AI Conversation Mode - how far the AI takes the SMS conversation:
- Only welcome message - AI writes the first text and stops.
- Short conversation (up to five messages)
- Long conversation (up to ten messages)
- Delay conversation messages (only when the mode isn’t “Only welcome message”) - adds a short, human-like pause before each reply.
- Enable AI Follow-ups (same condition) - the AI automatically texts leads who haven’t responded.
- Max AI Follow-ups (shown when AI Follow-ups is on) - how many AI follow-up texts to send, 1–3.
Two separate SMS delays. Delay sending of welcome message (in the SMS panel, available in both predefined and AI mode) holds only the first text. Delay conversation messages (AI Short/Long only) adds a pause before each of the AI’s later replies. They’re independent.
The AI’s Instructions for the AI and Knowledge base aren’t set here - they come from the shared AI settings on the AI Assistant page. You write those once and both the primary channel and SMS use them.
The SMS AI channel keeps its own conversation and its own limits, separate from the primary channel. A lead can use up the primary channel’s AI allowance and still get AI replies over SMS, and vice versa. SMS replies are kept short to fit the text format.
When the SMS welcome is sent
- The SMS welcome needs the lead’s phone number at the start of the conversation. It is sent right after the welcome on the lead’s original channel when the phone is known by then (for example, the customer included it in the first message). A phone number the customer shares later in the conversation doesn’t start an SMS conversation.
- It is sent only after the SMS Messaging registration for the sender number is approved.
- Delay sending of welcome message in the SMS panel holds it for the number of minutes you set.
Consent and opt-outs
- Outbound SMS is checked against the business’s phone suppression list before every send.
- A reply consisting of
STOP,QUIT,END,REVOKE,OPT OUT,CANCEL, orUNSUBSCRIBEsuppresses the number immediately for that business. - An opted-out number is blocked from both outbound SMS and outbound voice calls for the same business.
- Each send attempt and opt-out is stored with its lead-source snapshot and suppression state for phone-number audit queries.
SMS follow-ups
SMS has its own follow-up sequence, configured on the Follow-ups tab under the SMS Follow-ups sub-tab - separate from the primary channel’s follow-ups. SMS follow-ups only send while SMS Messaging is enabled here. See Follow-ups.
Pricing and registration
US carriers require every business that sends application-to-person texts to register first. NZ Leads walks you through it in the SMS Messaging dialog (titled “Setup SMS Messaging”).
What it costs
The dialog shows a “SMS Messaging registration pricing” panel - “Review and approve charges before submitting for compliance review” - with:
| Charge | Amount | When |
|---|---|---|
| Brand registration | $5.00 | One-time fee when a new brand registration is required. Renewing or reactivating SMS Messaging later keeps your brand, so it isn’t charged again. |
| Campaign review | $15.00 | Charged for each new campaign submitted for compliance review: the first submission, renewing after you cancel, and reactivating after the campaign was removed while billing was inactive. |
| Campaign resubmission | $0 additional | A rejected campaign is corrected and resubmitted under the original review fee. |
| Every month | $2/month | Charged after approval, while SMS Messaging is active. Outbound texts are also billed at $0.05 per SMS segment. |
A first registration is $20.00 in all ($5.00 + $15.00). The panel lists only the charges that apply to your next step.
These charges are on top of your normal per-source subscription. The “no setup fees” note on the Pricing page refers to source subscriptions - SMS Messaging registration is its own opt-in cost.
What you submit
Registration collects two groups of details:
- Business profile - legal business name, business type and industry, registration ID type and number, regions of operation, website, physical address, and an authorized representative (name, email, phone, job position).
- SMS compliance - company type, Privacy Policy URL, Terms & Conditions URL, a campaign description, how customers agree to receive SMS (opt-in flow), and message samples. Sensible defaults are pre-filled; edit them to match your business.
The Privacy Policy URL and Terms & Conditions URL must be two different pages, and each one must actually open. Before the submission is accepted we load both links: a link that returns “page not found”, or two links that lead to the same document, is rejected in the form. Carrier reviewers open these pages by hand, so a wrong link means a rejection and another round of review.
After you submit, the business profile, SMS compliance product, brand, and campaign all go through carrier review, and approval is not instant (typically a few business days).
Registration status
| Status | What it means | What to do |
|---|---|---|
| Not started | Nothing submitted yet. | Click Submit for Review. |
| In review | Under carrier review. | Wait - fields are locked during review. |
| Approved | Passed review; SMS can send. | Nothing - texts now go out. |
| Rejected | Review failed; specific reasons are shown. | Fix the flagged details and click Save & Resubmit. |
| Cancelled | SMS delivery is paused. | Click Renew SMS Messaging to resubmit (may incur a new review fee). |
You can pause an approved registration with Cancel SMS Messaging; the monthly fee stops after cancellation is processed.
Troubleshooting
- No texts are going out - Confirm the lead has a phone number, Enable SMS messaging is on, a Sender Phone Number is selected, and the SMS Messaging registration shows approved (a pending or error state on the button means it isn’t sending yet).
- The SMS Messaging button shows an error - Registration isn’t in place (not submitted, rejected, or cancelled). Open it and submit / Save & Resubmit / Renew.
- SMS follow-ups aren’t firing - They require SMS Messaging to be enabled on this source. The SMS Follow-ups tab warns “SMS is not enabled. Enable SMS in Conversation Setup before SMS follow-ups can be sent.”
- My welcome text was cut off - SMS welcomes are capped at 160 ASCII characters (one segment). Shorten the message or remove non-ASCII characters.
Questions about SMS Messaging? Email support@nzleads.com.